![]() The VLANs that are not displayed cannot be used in the interface range command. To display the VLAN SVIs, enter the show running config command. You can use the interface range command on the existing VLAN SVIs only. Support for extended VLAN addresses added. Support for this command was introduced on the Catalyst 4500 series switch. Interface configuration mode Command History Port range for a list of valid values for port-range, see the "Usage Guidelines" section. ![]() Specifies a VLAN range valid values are from 1 to 4094. macro auto execute (user-defined function).macro auto execute (remotely-defined trigger).mac-address-table dynamic group protocols.logging event trunk-status (interface configuration). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |